How To Do A Solid Axle Swap On A Durango. Solid axle swap kit ip: After tons of wire brush cleaning and tons of quarters at the car wash it was all clean.
Solid Axle Durango Guy?? | Pirate 4X4 from www.pirate4x4.com
The connector that screws in and turns on the dash light is removed and replaced with the vacuum switch, then vacuum lines are run from manifold to switch and axle accuator. Some kits also specify lift spring perch measurements or require the use of spacers. I want to get to 40s.
After Driving For A Few Months Found Out That Everything In The Front Was Lose And.
So the plan is to create a nasty durango. The story of my 1998 dodge durango solid axle swap in 2009 i totaled out my 2003 durango in a roll over in alaska over the winter. I call it the bangdango.
Then Comes The Clean Up, The Engine Dripped Oil All Over The Axle.
I am looking for just a leaf spring front and rear. The solid axle design allows. I don't think i would even want to.
It's Been Incredibly Reliable Up To Date With The Stock 318.
Do this for all four wheels. The punch mark will always be your reference point to align the axle. Check out some of the swaps in the forums there are different ways, myrtle and i went the route of radius arms and coils.
Depending On The Application, Cutting Off Mounting Points On The Frame May Be Required As Well.
The coil spring perches will have to. Some kits also specify lift spring perch measurements or require the use of spacers. Clean interior, no cracks in the dash, no rips in the cloth interior, a few small cigarette burns but nothing major, everything works.
Factory Ifs In Most Any Vehicle Won't Even Compare To The Solid Axles.
1 ton tie rod ends in steering. Then just get rid of the flip kit to who ever buy's your tc lift. Discussion starter · #1 · jul 23, 2008.
Post a Comment for "How To Do A Solid Axle Swap On A Durango"